DC Power Meter Sensor - PWR-DC-VOLT Pinout

noelmnoelm
in InfraSensing Sensors
I'm looking for the pinout for the PWR-DC-VOLT sensor. I'm using it in an application just measuring a -48V DC Plant, and just need to know which of the header connectors is for sensing DC. I can't find direct reference to it in any manuals.

Regards,
Noel

Comments

  • SchottkySchottky
    edited June 2018
    Hi Noel, I've seen this label on the PCB,
    please see below attachment
  • SchottkySchottky
    DC POWER VOLTAGE PIN-OUT
  • noelmnoelm
    So, which V and GND is the voltage sense, and which is the current sense?
  • DhaneDhane
    edited June 2018
    noelm said:

    So, which V and GND is the voltage sense, and which is the current sense?

    The middle one is for Voltage
    The right side is for Current Transducer Connection

    Kindly check the User Manual at Page 40 to 44
    http://manuals.serverscheck.com/InfraSensing_Sensors_Platform.pdf
  • noelmnoelm
    Dhane said:

    noelm said:

    So, which V and GND is the voltage sense, and which is the current sense?

    The middle one is for Voltage
    The right side is for Current Transducer Connection

    Kindly check the User Manual at Page 35 to 38
    The manual refers to a device called the "PWR-DC-METER". My device is a "PWR-DC-VOLT". I just want to be 100% sure before I cause damage to the sensor because there was a design change in the pin-out.
  • SchottkySchottky
    elise26 said:

    DC POWER VOLTAGE PIN-OUT

    Just want to correct my mistake that on the right side, the label was I not V.
  • DhaneDhane
    noelm said:

    Dhane said:

    noelm said:

    So, which V and GND is the voltage sense, and which is the current sense?

    The middle one is for Voltage
    The right side is for Current Transducer Connection

    Kindly check the User Manual at Page 35 to 38
    The manual refers to a device called the "PWR-DC-METER". My device is a "PWR-DC-VOLT". I just want to be 100% sure before I cause damage to the sensor because there was a design change in the pin-out.
    It is the PWR-DC-VOLT, we will coordinate about the typo on the manual

    but please do check it at the User Manual at Page 40 to 44
    http://manuals.serverscheck.com/InfraSensing_Sensors_Platform.pdf
Sign In or Register to comment.